Product: 15s du2060tx. I have been trying to boot from USB drive , but in BIOS options screen there is no Legacy support and Legacy boot order. Tried disabling the Secure boot and moved USB flash drive/ USB hard disk to top position , but unable to find the bootable USB drive in boot screen when pressed F9. Need help ! By pressing F12, two options appear as UeFI boot devices: 1- Windows boot manager, 2- UEFI hard drive, by pressing both option the Windows 10 is started. I have tested many options in the bios (for example, disabling secure boot) but the usb boot option does not appear. In the bios, it is noted that "the legacy boot option is not supported on The BIOS settings menu is accessible by pressing the f2 or f6 key on some computers. After opening the BIOS, go to the boot settings. Notebook computers: Select Storage > Boot Options . Desktop computers: Select System Configuration > Boot Options . Follow the on-screen instructions to change the boot order. I've tried to installed it from USB key but impossible to boot from it. I know I've to use Legacy option but I don't see where is the option to activate the Legacy Boot. There is only UEFI option. The laptop is HP Laptop Model 15s-fq2037nb. Be alert for scammers posting fake support phone numbers and/or email addresses on the community. Check Legacy Support and disable if it is enabled: System Configuration > Boot Options > Legacy Support or Boot Options > legacy Support; If Legacy Support is DISABLED, skip to Procedure 3, Step 3. If Legacy Support is ENABLED, change it to DISABLED, save the changes and exit, then go to Procedure 3. 3-now we going to the motherboard bios once the laptop start hit escape or f10 then go to security , boot, looking for Eufi and legacy choose EUFI without csm then above that mark on the secure boot and save the setting Your laptop will restart. KAbfG. The first thing to note is that the exclamation point (!) to the left of a boot order item, means that the computer is not detecting any items that qualify for booting. Specifically you USB Floppy is only enabled when actually have a USB 3.5 floppy drive connected. Yes No. 4 REPLIES. DGroves. 6,029 1,353 557. Level 12. 01-13-2021 09:43 AM. reset bios back to defaults, and both legacy/UEFI will be enabled. if not then disable TPM in the bios, not all systems allow you to do this via the bios you may need to use the BCU app under windows to change this setting. you MUST create BIOS administrator's password When I set it in UEFI mode my SSD isn't listed. (Either with secure boot On or Off) When I'm in Legacy, it doesn't find a bootable drive. I can only boot when I set it in Legacy and then manually start the Windows Boot Manager from the boot menu when you press f12. Once I'm booted I CAN see my drive listed on diskpart in cmd. Solution. #2. first thing i would attempt, possibly again for you, is; formatting both drives, remove the HD, determine if your laptop has a specific OS drive location (some have had auto-boot priority set to a certain SATA port), connect the SSD to the needed SATA port, perform a fresh install to the SSD. 3, Press F9 to open the Boot Device Options menu. 4. Use the up or down arrow key to select the recovery USB device, and then press Enter. Note: If you cannot select the USB flash drive from the Boot Menu, disable Secure Boot and enable Legacy Mode in BIOS. 02-15-2021 06:43 PM. @DaveC11. If there is no Legacy option in the BIOS, you will not be able to install a Linux distro on your drive and then boot it. Modern PCs often now come without Legacy (or CSM) boot options and only have UEFI. Also, we do not provide support for Linux, installation or booting. So you will need to contact the support

hp laptop legacy boot option not showing